Lighting fireplace pilot light. Procedure for lighting a standing pilot in a gas fireplace or other gas appliance. If the on switch is left on for more than 60 seconds and the pilot does not light the fireplace will go into lock out mode. Repeat this step as necessary until the pilot ignites.
Dont worry heat glo provides helpful step by step directions for relighting your pilot light. After lighting the pilot continue to hold the control knob in for about 30 seconds or the pilot may go out. Turn gas control knob clockwise to the off position and turn onoff switch to off position.
I just had it serviced getting the themro couple replaced and it was working yesterday went to switch it on this morning and it wouldnt ignite the pilot light is on. How to light a gas fireplace pilot light most gas fireplaces have a standing pilot light which is a small flame that burns even when you arent using the fireplace. Be sure to smell next to the floor because some gas is heavier than air and.
With the pilot light ignited turn your fireplaces control knob from the pilot position to the on position. The following demonstrates how to ignite your pilot light on a napoleon gas fireplace. This makes the fireplace easy to start when its cold outside but when it warms up its a good idea to shut off the pilot to conserve gas.
If the pilot does not light within 45 seconds turn the onoff switch back to the off position and wait 15 seconds. For your convenience we made a video with step by step instructions on the proper procedure to relight your pilot located in the control panel of your fireplace. Wait 5 minutes to clear out any gas.
Light the pilot on a gas log fireplace by turning the gas flow knob to the pilot setting holding the knob in and using a match to ignite the pilot. When lighting the pilot follow these instructions exactly. This will make sure the pilot light stays on indefinitely allowing you to activate the fireplace whenever you wish using the devices wall switch or remote control.